Thanks again.
Statistics: Posted by Ariajazz — 19 Oct 2023, 22:49
]]>
Did you check your rack settings ?
By default, a rack is calculated in serie. But there is an option to use them in parallel. Maybe you selected parallel and forgot it.
Otherwise, I don't know, it seems you did it correctly.
Can you share you're project ?
Sylvain
Statistics: Posted by SylvainT — 19 Oct 2023, 09:01
]]>
It's made as in a real rack
Audio from above goes in the audio in
and the audio out goes to the patch below
where
Audio from above goes in the audio in
and the audio out goes to the patch below
in your picture audio goes in the MXR DIST and then in the KLON
Statistics: Posted by grego mondo — 19 Oct 2023, 08:58
]]>
Statistics: Posted by Ariajazz — 18 Oct 2023, 19:15
]]>
Statistics: Posted by joffo78 — 18 Oct 2023, 16:06
]]>
I build each patch separately, so each one has AUDIO IN and AUDIO OUT modules, the problem is that when two or more patches are placed in a rack (in series) they all will pick the same audio signal from the INPUT stage of the rack acting more as a PARALLEL system. I hope I'm explaining myself propperly and that you get the idea. I need the audio signal flow to be IN SERIES.
The other thing I want to know is how do I connect or transmit the resulting audio signal from one rack to the next one and continues the audio flow until it reaches the final OUTPUT stage of the workspace. I used to know how to do this in old USINE 5 but HH is a bit different and to be honest I don't remember exactly how I used to do it. I guess in HH is by dragging and dropping method
Any help on this will be greatly appreciated. Thanks in advanced.
Statistics: Posted by Ariajazz — 17 Oct 2023, 23:09
]]>