leap motion with Orion 4.1 on windows10
Posted: 10 Jun 2021, 22:30
Hello Usine users,
I'm experiencing weird problems with my Leap device in Hollyhock 4 march or may 21 versions. The device works nicely with the Leap Visualizer and calibrate well. But with the leapmotion object in Usine, I only get the dir parameters of palms and fingers but pos parameters just stuck on 0.25 for X and Y and 0.75 for Z. Strangely, it happens on a new PC, the previous one, stolen 10 days ago, was fine. Do anyone know something about this big ? Maybe something changed in Windows that causes problem with the Leapmotion object... ? Thanks for your feedback.
François
I'm experiencing weird problems with my Leap device in Hollyhock 4 march or may 21 versions. The device works nicely with the Leap Visualizer and calibrate well. But with the leapmotion object in Usine, I only get the dir parameters of palms and fingers but pos parameters just stuck on 0.25 for X and Y and 0.75 for Z. Strangely, it happens on a new PC, the previous one, stolen 10 days ago, was fine. Do anyone know something about this big ? Maybe something changed in Windows that causes problem with the Leapmotion object... ? Thanks for your feedback.
François