Welcome to %s forums

BrainModular Users Forum

Login Register

MIDI seems to "break" when I put two Piano rolls in series?

General Discussion about whatever fits..
Post Reply
loneboat
Member
Posts: 18
Location: Arkansas
Contact:

Unread post by loneboat » 18 May 2015, 20:17

See screenshot below. I'm learning about the "Midi Piano Roll" from the library. If I add one and put a VST after it, it works just fine. If I try to "chain" two piano rolls together, then it SORT OF works, but some notes get stuck on. As though some of the NOTE OFF messages are being lost. Is there a better way to do this? I want to send two piano rolls to the same VST.

Thanks!

Image

shawnb
Member
Posts: 190
Location: San Francisco
Contact:

Unread post by shawnb » 18 May 2015, 22:12

Have you tried putting them in parallel?
Address the process rather than the outcome. Then, the outcome becomes more likely. - Fripp

loneboat
Member
Posts: 18
Location: Arkansas
Contact:

Unread post by loneboat » 18 May 2015, 23:23

No, I haven't. How do I put patches in parallel? Would that involve an additional rack? Or can you do parallel patches in a single rack? (If it's an additional rack, I don't know how I would go about getting the extra rack's output back into the VST)

Thanks so much for your reply! :-)

User avatar
nay-seven
Site Admin
Posts: 5684
Location: rennes France
Contact:

Unread post by nay-seven » 18 May 2015, 23:39

you can create sub patches and link them in parallel
here an example

Post Reply

Who is online

Users browsing this forum: No registered users and 129 guests