storing the state of a switch in conductor

[nofish]

Again, not sure if it's a bug or am I doing something wrong.

For demonstration I have made a simple patch:

For snapshot 0 I have put the pass button (switch)off (unlit), for snapshot 1 I have put the pass button on (yellow lit).
When I change from snap 0 (pass button is off) to snap 1, everything ok, the button changes from off to on.
But when I recall snap 0 again from snap 1, the button just stays on. I expected it to go off again.
What's going on here?

[moody33]

Are you sure that you have "rewrite" snapshot 0?

[nofish]

Yes, unless I did something wrong I'm quite sure.
Tested several times.

Could somebody else check this on the latest beta please?