Routing mobius vst "out" to Usine's "Tracks"

[javanaiz]

Hello !
I'm trying to route VST Mobius's multiple "out" to a Usine "tracks"
Mobius is a virtual vst looper.

I 'd like to make it work this way :

On "Track 4" is Mobius vst

Then
"out 1"' (from mobius vst module) goes to "track" 1
"out 2"' (from mobius vst module) goes to "track" 2
"out 3"' (from mobius vst module) goes to "track" 3

Is there a way to do it ?

Note : on the right side of the picture are some of the module I tried to use unssucssfully
thanks j.

[nay-seven]

hé hé javanaiz..always fighting with Mobius..?
the send to new audio bus would be the solution, you'll have then out1,out2...
then in track 1 use the get from existing bus from your effect audio in or whatever you have in this track and choose out 1
i can add screenshot if needed

check here too about target for buses

[gurulogic]

maybe too much information for now, but if you want phase perfect audio sync between the direct outs (1&2) from Mobius and the bus tracks from mobius, you should delay the direct outs by one bloc as the bus audio is always automaticly delayed by one bloc. (buffer)

[javanaiz]

Hey Nay 7
yes I'm still strugling with Mobius
I don't know what I got with Busses.
I always forgot about the way it works
Thanks it works fine with your help !

I also found the tutorial about "Communication between patches and tracks"
really nice about how it works
http://sensomusic.com/wiki/doku.php?id= ... h:chapter3

Gurulogic : thanks about pointing this,
but how do you do to delay the direct outs by one bloc in Usine

[oli_lab]

isn't it "wait one cycle" ?

[unguitar]

hé hé javanaiz..always fighting with Mobius..?
the send to new audio bus would be the solution, you'll have then out1,out2...
then in track 1 use the get from existing bus from your effect audio in or whatever you have in this track and choose out 1
i can add screenshot if needed

check here too about target for buses

yes for the screenshot, please ( and thanks)

[nay-seven]

no problem: