BrainModular

See screenshot below. I'm learning about the "Midi Piano Roll" from the library. If I add one and put a VST after it, it works just fine. If I try to "chain" two piano rolls together, then it SORT OF works, but some notes get stuck on. As though some of the NOTE OFF messages are being lost. Is there a better way to do this? I want to send two piano rolls to the same VST.

Thanks!

Have you tried putting them in parallel?

No, I haven't. How do I put patches in parallel? Would that involve an additional rack? Or can you do parallel patches in a single rack? (If it's an additional rack, I don't know how I would go about getting the extra rack's output back into the VST)

Thanks so much for your reply!

you can create sub patches and link them in parallel
here an example