Page 1 of 1
Posted: 16 Jan 2017, 22:27
by BatKam
Hello,
I'm having a big issue : I just bought an Enttec open dmx usb and it doesn't work in Usine. In the configuration pannel of the MAC, it recognizes it as FT232R USB UART. But Usine can't detect it...
Any suggestions ?
It would be so nice!
Thanks in advance
BatKam
Usine Hollyhock 84a, OSX 10.9.5
Posted: 22 Jan 2017, 10:39
by nay-seven
Enttec drivers issue. Solved by email answer
For those who encounter the same, check this
Enttec page, they have a specific tool to update their drivers and solve this.
Posted: 12 Feb 2018, 19:10
by hgermain
Hello, i have the same issue, but i can't find on the enttec website the tool you are talking about...
thanks!
H
Posted: 12 Feb 2018, 21:12
by oli_lab
I strongly recommend the artnet DMX king series !
Posted: 13 Feb 2018, 10:24
by hgermain
thanks for the recommandation! but i already have the enttec :-/
Posted: 14 Feb 2018, 11:08
by hgermain
Oli LAb, why do you prefer the artnet DMX king series?
as it stil doesn't work with enttec, i might consider buying one...
thanks
Posted: 14 Feb 2018, 13:12
by iococoi
Posted: 14 Feb 2018, 13:29
by oli_lab
hgermain wrote:Oli LAb, why do you prefer the artnet DMX king series?
as it stil doesn't work with enttec, i might consider buying one...
thanks
I prefer Ethernet more than USB !
with Artnet, your computer is connected on a LAN as is the DMXKing.
you can hot plug everything, if there is a loss of power every thing get recconected automatically.
Posted: 14 Feb 2018, 16:28
by hgermain
thanks Lococol i give it a try!