Posted: 24 Jul 2015, 10:44
Hello everybody!
1. For whatever reason "step data" and "sequenced lines" changes can not be automated in Hollyhock 2 (trace panel says: "Warning: W016 this control can not be recorded").
In Hollyhock 1.x it was possible to record automation for step and lines data.
Why so?
It would be great to re-establish this function in HH 2.
2. And also it would be great to show the name of automated parameter in the automation curves boxes. Sometines it is hard to keep orientation within dozens of curves.
best,
nik
1. For whatever reason "step data" and "sequenced lines" changes can not be automated in Hollyhock 2 (trace panel says: "Warning: W016 this control can not be recorded").
In Hollyhock 1.x it was possible to record automation for step and lines data.
Why so?
It would be great to re-establish this function in HH 2.
2. And also it would be great to show the name of automated parameter in the automation curves boxes. Sometines it is hard to keep orientation within dozens of curves.
best,
nik