Page 1 of 1
Posted: 29 Apr 2008, 16:58
by Vincent
One of the synchronisation modules (I dont remember which one) has a 'total bar position' outlet, which is very usefull.
Could it have a 'Marker position' outlet too?
And an 'is in loop mode' outlet?
Posted: 29 Apr 2008, 18:07
by senso
Actually there is only a 'goto markers' module.
I can add in 'sequencer commands' module Markers info (time) and 'loop' state.
Posted: 29 Apr 2008, 21:36
by Vincent
senso wrote:Actually there is only a 'goto markers' module.
I can add in 'sequencer commands' module Markers info (time) and 'loop' state.
Yes, thanks!
The 'goto markers' module is nice.
A 'loop' state would be greatly helpfull.
Thanks, Olivier.