I am automating my sends from the racks.
I have 9 sends to automate.
The problem is when I click on the rack in the grid, the inspector just shows me a list of "gain's" that I have chosen to automate
terms.ie:
gain
gain
gain
gain
gain
gain
etc.
So I have no idea which curve goes with what send.
It should read
Echo Gain
Delay Gain
Reverb Gain
FX1 gain etc
its making it really hard work to know whats going on, and edit the curves
Grid Problem
can you provide a simplified example of your grid to help us understand the issue?
-
Pianoscope
- Member
- Posts: 57
- Contact:
Hi Nay.
Heres a photo that explains it. I
Rack 6 is sending to the others. I am automating each send in the grid, as you can see when I want to edit later, I don't know which send the curve corresponds to.
https://www.flickr.com/photos/58771997@ ... res/9ze9is
Thanks!
Leon
Heres a photo that explains it. I
Rack 6 is sending to the others. I am automating each send in the grid, as you can see when I want to edit later, I don't know which send the curve corresponds to.
https://www.flickr.com/photos/58771997@ ... res/9ze9is
Thanks!
Leon
Yes, currently it's not possible to rename these gain fader or find a workaround
will be solved in the next release
will be solved in the next release
-
Pianoscope
- Member
- Posts: 57
- Contact:
thats good to know, my workaround is to use a piece of paper....
(when I map a parameter to an external midi controller and then automate it in the grid, weird things can happen when copying and pasting the grid section. The parameter being automated doubles itself on the new pasted section appearing twice, as if overlaying on itself. Ill investigate more fully after my next performance, just focussing on getting everything stable for the moment)
other grid desires,
Being able to individually name rack sections
copy and paste curves between racks, i.e. copy a curve from rack One and paste on to a selected parameter on rack Two
Grid override toggle switch, per rack/ grid section disabling the curves so manual control using external controllers is possible mid performance.
If I have to lower the volume of a track mid set its not possible if the level is automated.
My workaround is to have short pre sections that set up the automation parameters, followed by a section that has no automation so I can alter if needed.
multiple selection of sections
(when I map a parameter to an external midi controller and then automate it in the grid, weird things can happen when copying and pasting the grid section. The parameter being automated doubles itself on the new pasted section appearing twice, as if overlaying on itself. Ill investigate more fully after my next performance, just focussing on getting everything stable for the moment)
other grid desires,
Being able to individually name rack sections
copy and paste curves between racks, i.e. copy a curve from rack One and paste on to a selected parameter on rack Two
Grid override toggle switch, per rack/ grid section disabling the curves so manual control using external controllers is possible mid performance.
If I have to lower the volume of a track mid set its not possible if the level is automated.
My workaround is to have short pre sections that set up the automation parameters, followed by a section that has no automation so I can alter if needed.
multiple selection of sections
Who is online
Users browsing this forum: No registered users and 6 guests