adding buttons to program change control

[seamus]

I have got program change messages going from my controller to the conductor to change patches. this works great.
I would also like to add buttons to easily go up or down.

The buttons I added aren't able to change the patch though. They try but are blocked somehow.
I think I have to add a pass if changed module to allow both ways to work together but Im not sure how to patch this.

[nay-seven]

yes, without pass if change the midi in module ( or fader or whatever else) is the master control so buttons can't work
so place the pass if change module between the midi in and the inlet num of the conductor.

[seamus]

Im so stupid. That was embarrassingly easy! Haha

Thanks Nay