Control Rack on-off

benjotrash · Unread post by **benjotrash** » 14 May 2019, 08:44

I am facing a little problem with my interface builder.

I try to show a led in the Interface Builder when a rack is on, but in the usine rack module the on-off cannot be connected... Is there another way to do this?

Thank you very much for the help...

Benjo

iococoi · Unread post by **iococoi** » 14 May 2019, 09:18

hi,
there is an enabled outlet..you could use this..

benjotrash · Unread post by **benjotrash** » 14 May 2019, 11:30

Looks good. But this only works for a patch? . How can I Show the status of the rack?

nay-seven · Unread post by **nay-seven** » 14 May 2019, 13:42

Create a new rack and add a rack settings module, select the rack number and use the on outlet

benjotrash · Unread post by **benjotrash** » 14 May 2019, 14:26

But there is no on outlet. In the configuration window it is, but can not be connected...

iococoi · Unread post by **iococoi** » 14 May 2019, 14:31

sorry i dont understand..u need the status of a rack? if its enabled then its on, isnt it?

benjotrash · Unread post by **benjotrash** » 14 May 2019, 14:34

Where can I get that rack settings module you are using above? As you can see,in my rack settings there are less in and outlets....

iococoi · Unread post by **iococoi** » 14 May 2019, 14:36

benjotrash · Unread post by **benjotrash** » 14 May 2019, 14:38

Uh nooooo!! Sorry to waste your time ðŸ¤£... Didn't know that....

Thank you!!!

iococoi · Unread post by **iococoi** » 14 May 2019, 14:40

not to worry..

iococoi · Unread post by **iococoi** » 14 May 2019, 14:46

nay-seven wrote:Create a new rack and add a rack settings module, select the rack number and use the on outlet

nay, is there a difference between on and enabled besides the outlet?

Welcome to %s forums

Control Rack on-off

Login • Register