remember conductor preset??

woodslanding · Unread post by **woodslanding** » 17 Jun 2009, 16:00

I wired up a fader to the conductor input, and made it not stored in conductor, but usine still always sends me back to preset #0 when I startup usine.

I'd like usine to remember the last preset I used. In fact, that seems like appropriate default behaviour.

Thoughts??

Thanks,
-eric

nay-seven · Unread post by **nay-seven** » 17 Jun 2009, 19:26

try this way :

woodslanding · Unread post by **woodslanding** » 19 Jun 2009, 02:18

that's what I tried, and it isn't working. I also made sure that the fader was not stored in the conductor.

Oh wait---you have the pass if changed hooked up to DEFAULT VALUE!!

I see! The default value will get sent when Usine starts?? I will try this out.....

Thanks!!!

woodslanding · Unread post by **woodslanding** » 24 Jun 2009, 08:28

Dang, there is no default value for a combobox! I'm even willing to type every preset name into a combobox, and I STILL can't use it to control the conductor!?

Ideas??

cheers,
-e

23fx23 · Unread post by **23fx23** » 24 Jun 2009, 08:55

you can watch the "init" module in interface control, it send an impulse when usine engine is swiched on, you can connect it to the pass inlet of a pass module that will reset the combobox to desired value in. or to remember the las,t use nay tek and connect the out of the fader to a "pass if change" connected to the combobox.

woodslanding · Unread post by **woodslanding** » 02 Jul 2009, 10:41

I will try that again..... I tried it once, but I must not have wired it right.

Welcome to %s forums

remember conductor preset??

Login • Register