How to build MIDI thru

[lapidar]

Hopefully some typical beginners problem:

My Midi In signal in Usine isn't passed to Midi Out.
I can see midi-in traffic bar flashing in my rack, so Usine seems to get a signal but it doesn't pass through to midi out.
What did I do wrong? Is the generated Midi In module automatically mapped to my midi device? (I have only one midi device enabled)

The piano roll in the same setup plays out notes successfully though.

[drakh]

and have you droped your midi device into rack input ?

[lapidar]

Yes, midi device is in rack.
Meanwhile I tested a stepsequencer (Thesys) at the same virtual midi in and it works!

The problem occurs when I use Ctrlr as midi input which is sending out only cc or sysex (will check again). No note on/off.
But I also saw the peaks in the rack device when using Ctrlr!
Does Midi In filter something? What does the red [-1] mean in sysex field and Midi 1 saying "No Midi"?

[senso]

I confirm, it should (and it does) work as expected.
Check if you have a channel filter somewhere in the chain. Check also if you have several midi in/out modules in your patches.