Introduction Modules Laser Modules Laser Video to Laser

Laser Video to Laser

Transforms a video flow into a set of (X,Y,Z,COLOR) points that can be handled by an ILDA compatible device.

The conversion is made with a contour detection and a simplification of the image.

Settings

video in

Video input flow(s).

video out

Video output flow(s).

process time

Total time used for the calculation of the module.

on

Activates or deactivates the module.

laser xyz

Frames points coordinates a 3D array (X,Y,Z) points. Can be modified by 3D modules.

laser colors

Array of colors for each point.

laser status

Array of status of the laser for each point: 0 for laser OFF and 1 for laser ON.

threshold

Threshold of the contour detection.

size precision

Precision in pixel of the drawing. In other words, amount of simplification of the image.

dwell

Laser DWELL. Laser head inertia compensation. Number of "phantoms" points between lines.

A laser dwell is a period of time during which a laser beam is held in one spot, typically used in laser cutting or laser welding. During this time, the energy from the laser beam is concentrated on a small area, allowing for precise and efficient cutting or welding.

min line size

Minimum line size for the drawing.

frame color

Color of the output ILDA frame (colors out).